Watch installation video 01. Pill the tape Peel the sticker to expose the adhesive. 02. Attach it to the surface Place the film where the pigeons used to stand and stick it to the surface. 03. Lift the two aluminum wires At the end of the film, detach and slightly lift the aluminum strips. 04. Tighten the connectors tightly on the wires Connect electrical wires using the connectors to the raised aluminum ends. 05. Connect the electric wires to the charger The power cords should be connected to the charger you purchased with the kit. 06. Connect the charger to the outlet Just plug the power supply in. TIPS How to make corners and branches using the shock Tape while maintaining a continuous electric current CornerT branchCorner 01. Cut the film at 45 degrees and snap the films to create a corner. Lift the aluminum edges. 02. Insert the connectors 03. Bridge between the tracks with power cord 04. Press the connectors with the power cord 05. Flatten the connectors and cover the connection with a transparent adhesive strip T branch 01. Connect two ribbons lengthwise 02. Insert connectors without closure 03. Paste the vertical film 04. Connect between the movies 05. Gently flatten the connectors 06. Cover the connection with a clear strip of glue